Address:

Industrivej 9 – DK-3540 Lynge

Phone:

+45 47 17 18 55

Email:

Opening Hours:

Mon-Thu 8:30 - 16:30 & Fri 8:30 - 16:00

BITEEREX PLUS

BITEEREX PLUS




Bitumen release agent for hot and melted asphalt

Description

BITEEREX PLUS is a low-viscosity, hydrocarbon-based, ready-to-use release agent for asphalt and bitumen. Thanks to its good release effect the product is suitable both for melted as well as for hot asphalt.

Fields of application

Asphalt mixing plants, asphalt recycling plants, road finishing machines, truck loading platforms, and other equipment.

Method of application

BITEEREX PLUS is applied thinly and uniformly with a brush or suitable spraying device (with Teejet nozzle SS 1100067 or SS 800067). Consumption ranges between 20 and 30 m2/l.* The spray pressure should be maintained above 5 bar.

BITEEREX PLUS must not be diluted with water, oils or solvents – it is ready for use!

*A test report (No. 2015/141-2) by Technische Universität Kaiserslautern/Materialprüfamt (Material Testing Institute of Technical University Kaiserslautern) is available.

Note

  • The duration of storage should not exceed 1 year.
  • Store barrels horizontally.
  • Seal container after use in order to prevent active ingredients from escaping at higher temperatures.
  • Re-seal container after use.

Please observe water resources policy act and EU safety data sheet!

Prior to its use on rubber-tire rollers, seals, etc., the compatibility with the elastomers should be verified.

The product may not come in contact with zinc or galvanised materials.

In winter a spraying pressure of 6 to 12 bar may be required.

Features

  • economical to use
  • no release problems when transporting asphalt on truck loading platforms
  • very good release effect, even with stone mastic asphalt
  • Ready-to-use
  • no labelling required according to the respective regulations